• Answers
  • Web
Originated from
AOL Search

My drain is from a double bowl sink . The drain ...

My drain is from a double bowl sink . The drain comes from each side to the center. They join into a T which is connected to a trap and the drain then goes into the wall. There is no real drop in the pipes, and no place to put in a drop pipe with the neck for the dishwasher drain to enter into. Do I need to install a new drain that goes through the floor and then connect into the drain in the basement?


Share Send to a friend Watch Report
 
 

Posted Answers

No answers were posted yet - be the first one to answer!

Sign in to participate

Got an answer for john? Would you like to comment on the posted answers, or vote for the one which you think is the best?

Sign up for a free account, or sign in (if you're already a member).

Explore Related Questions

Other people asked questions on similar topics, check out the answers they received:


Q:

My dishwasher is draining through the vent instead ...

My dishwasher is draining through the vent instead of the normal route. All over the counter tops and under the sink. HELP
Submitted by homesrtd   2 years ago.
  • viewed 108 times
Last answer posted 2 years ago by profitbob


Q:

Dishwasher not draining water and flooded my floor.

dishwashers
Submitted by bronco   1 year ago.
  • viewed 45 times


Q:

Dishwasher water keeps running and overflows onto ...

dishwasher water keeps running and overflows onto floor. Had to turn water off to stop it. Float switch is not stuck.
Submitted by Mike   11 months ago.
  • viewed 63 times



» More...

Explore Related Posts in Forums

How can I check whether a (TCP) socket is (dis)connected in C#?

How should I check a (TCP) socket to find out whether it is connected? I have read about section also notes that: If you need to determine the current state of the connection, make a nonblocking additional (payload) data. When the socket is connected, Receive() will block until the socket receives

Where do you connect the tach on DIS?

I have a 1990 Ranger with a 2.3L DIS. The Chilton's manual I have for it shows the wiring diagram next weekend and see how it works.I got it to work. The Haynes manual has a good diagram of the DIS it goes to pin 4 on the PCM which is the same connection point as the V6. I'll have to try it out

DIS-connected O2 Sensors

As-is How will having them disconnected affect the A/F mixture along with any other areas...??? It seemed I just (finally!) installed some Flowtech headers on my `88 GMW along with a 'custom' true dual 2 1/4" exhaust. I didn't ... have time to weld in the bungs for the O2 sensors and just drove it home as-is How will having them disconnected affect ...
» More...
Powered by
Feed - Subscribe to changes to this Q&A Blog
ADVERTISEMENT
  • Answers
  • Web
Copyright © 2006-2009, Yedda Inc. and respective copyright owners · CC License