When the coil was relocated was the wires reconnected the same way? disconnect the wires from the coil.turn on your key switch to run position ground the wires you unhooked from the coil one should spark that is your hot wire from the ignition switch. connect it to the + on the coil. connect the other wire should be coming from the points connect it to the - on the coil.

then double check the wire from the coil to the points to make sure it is connected to the points and not shorting out anywere.

check the points to make sure they are set properly .020 and make sure nothing is tuching coil cover and shorting out

 this should give you spark,  Bill at The Repair Shop